TFT screen problem

I just bought a new TFT screen but I can't get the foot to open. According to the very simple picture in the user's guide you just pull on it. Trying that though it feels like I am going to snap the foot off if I pull any harder. There is a little padlock icon on the back of the screen but no reference to it all in the user's book.

It is a Fujitsu Siemens Scaleoview C17-6. If anyone else has one of these would you mind letting me know how you got the stand opened.

 

Usually, there is a release button.

 

I believe one I've bought in the past had a pin you had to remove, the pin was in simply for shipping and packing and was not needed after you removed it. Others I've had are a bit hard to get it to move the first time around, very snug fit to say the least. Henny may be correct though as it might have a release button, either way I would think it would say so in the instructions somewhere.

 

I had the same prob with a sony.I lay it on a flat surface (screen down) then pushed the foot down and pulled.It worked.The instructions said exactly the same as yours....just a little diagram that says pull.I fiddled with it for ages before I finally got it and that was just by pure luck.

 

Stab it with a big knife.

 

That's exactly what I felt like doing. In the end I pulled and tugged and fiddled and it did finally snapped into place. That took the longest time of connecting the whole system.

 

umm send it over to me and I'll have a look... I'll be sure to send it back in a few months

 

At least credit your sources, McFox.

That should say:

 

Sorry, I thought it was a recognised DP policy.

 

HAHAHAHAHAHAHA.

Damn You must spread some Reputation around before giving it to minstrel again.


Minnie is by far the funniest poster on here. Word to yo' momma!

 

HodgedUp just got nominated for that title in another thread.

I don't know if I can stand the suspense of another election

(Did you mean to search for erection?)